LINE VOLTAGE INFORMATION
ALARM
Line Voltages:
Phase A-B
208 V
Phase B-C Phase A-C
208 V 208 V
VISUAL AURAL SUPPLY EXIT
Figure 3-9. Line Voltage Information Screen
Line Voltage Information screen - This screen is displayed
when the LINE keyis selected while viewing either powersupply
information screen or a visual or aural information screen. This
screen displays each phase voltage of the three phases in the
system. These voltages are sampled at the control cabinet.
There are 4 active softkeys on this screen. They are:
VISUAL - This key will display the Visual information screen 1.
AURAL - This key displays the aural information in the system.
SUPPLY - This key will display the Power Supply information
of the transmitter system.
EXIT - This key will return the user to the Bargraph Meter screen.
Figure 3-10. User Setup Selection Menu
User Setup Selection Menu screen
This screen is called up when SETUP key is depressed while
viewing the bargraph meter screen (default).
This screen is used to select 1 of the 4 user available options.
There are 5 active softkeys on this screen. They are:
TIME - This key selects the Time and Date entry screen.
USER - This key selects the User Display Edit screen
TEST - This key selects the display panel test screen or Sentry
Setup.
SETPOINT - This key selects the Power Setpoints Edit System.
EXIT - This key will return the user to the Bargraph Meter screen.
3-8 888-2365-001 Rev. B: 1/11/1999
WARNING: Disconnect primary power prior to servicing.
To Next Page
Loading...
