TIME AND DATE ENTRY ALARM
Current: Date Time
9-MAR-1989 05:03:00
New: Date Time
9-MAR-1989 05:03:00
SET
TIME EXIT
Figure 3-11. Time and Date Entry
Time & Date Entry - This screen is displayed when the TIME
selection key is selected on the USER SETUP SELECTION
MENU screen. This screen is used to enter the time and date into
the system.
Thetime and date are recordered by the monitor system each time
fault occurs.
There are 5 active softkeys on this screen. They are:
→- This key will move the field indicator to the next field of the
time and date group of fields. Use this key to select the field that
is to be edited. In the example shown, the field indicator is below
MAR.
- This key increments the value in the selected field by 1.
↓ - This key decrements the value in the selected field by 1.
SET TIME - This key updates the Time and Date with the user
edited value.
EXIT - This key will return the user to the User Setup Menu.
Use 24 hour format to enter pm times (i.e. 2:00pm = 14:00)
NOTE
DATE does not advance to a new year on January 1, and does
not automatically include Feb. 29 during a leap year. The year
entry must be changed maually at the beginning of each year. The
DayentrymustberesettoMarch1onthatdateduringaleap
year.
USER DISPLAY & D/A OUTPUT EDIT
ALARM
1 User Display Screen Edit
2 Digital to Analog Output Edit
USER D/A
Figure 3-12. User Display & D/A Output Edit
User Display & D/A Output Edit
USER - Used to display the Edit Bargraph Analog Source.
D/A - Used to display the D/A Output Edit Screen.
Section III - Operation, Controls, and Indicators
Rev. B: 1/11/1999 888-2365-001 3-9
WARNING: Disconnect primary power prior to servicing.
To Next Page
Loading...
