3-5
RF-7800W
SYSTEM ADMINISTRATION AND CONFIGURATION
3.5 NETWORK INTERFACE
The radio hosts a number of management interfaces that can be accessed via IP. This section describes the
information and configuration options available for basic network configuration. See Figure 3-4.
3.5.1 Ethernet Port
The subsections below describe Ethernet Port configuration parameters. All parameters for Ethernet Port can be
accessed using GUI, CLI, and SNMP interfaces.
3.5.1.1 MAC Address
This is the unique Media Access Control (MAC) address of the Ethernet port. It is set by the factory and not user-
configurable. This address may be required when setting up the wireless interface.
3.5.1.2 Port Mode
The Ethernet port can be configured to automatically detect the port settings based on the capabilities of the attached
device, or fixed to a particular port speed and duplex setting. Note that the port speed and duplex settings must be
compatible with the attached device, or communication could be disrupted.
Figure 3-3. General Information
To Next Page
Loading...
