51
05
,
Note General information
6-19
Features Approvals
For operating voltages over 50 volts, the connector
must be used with conductive housing parts, in
compliance with the safety directives in DIN VDE
410 / IEC 60364-4-41.
Connectors should not be connected or
disconnected while under electrical load.
It is the user’s responsibility to check whether the
components illustrated in this catalogue comply with
different regulations from those stated in special
fields of application which we are unable to foresee.
We reserve the right to modify designs in order
to improve quality, keep pace with technological
advancement or meet particular requirements
in production. This information describes the
components but should not be considered as a
guarantee of certain properties.
HARTING Electric GmbH & Co. KG
Wilhelm-Harting-Strasse 1
D-32339 Espelkamp, Germany
Phone +49 5772 47-97100
HARTING Electric@HARTING.com
• High contact density with up to 19 contacts
• Interchangeable combination of inserts and
hoods/housings
• No special tools for assembly process required
• Crimp, solder and solder-in termination technique
• 360° EMC capability
• Shock and vibration proof
• Robust hoods and housings for industrial
environment
Number of contacts
≤ 300 V
≤ 20 A
Han
®
M23 Signal
To Next Page
Loading...