What to do if low water flow is detected in my Hayward AquaRite 100 Water Pump?
If you're experiencing low water flow with your Hayward Water Pump, first check the plumbing for any obstructions or flow-related issues. Also, make sure to verify that the filter is clean.
What to do if no water flow is detected in my Hayward AquaRite 100?
If no water flow is detected in your Hayward Water Pump, first verify that the pump is turned on. If it is on, remove power for two minutes and then restore it.
How to turn on Hayward AquaRite 100?
If the power to your Hayward Water Pump is off, simply turn the power to the pump on.
What to do if AQR 100 of Hayward Water Pump is between generating cycles?
If your Hayward Water Pump's AQR 100 is between generating cycles, you can either wait until the next generating cycle begins or cycle the power to the AquaRite 100.
What to do if there is no power to AQR100 Hayward Water Filtration Systems?
If there is no power to your AQR100 Hayward Water Filtration System, turn the power to the pump “ON” and check the breaker.
What to do if there is no power to display in Hayward Water Filtration Systems?
If there is no power to the display of your Hayward Water Filtration System, test the voltage from the PCB to the display.
What to do if there is no power to PCB in Hayward Water Filtration Systems?
If there is no power to the PCB in your Hayward Water Filtration System, test the transformer.
General| Type | Salt Chlorine Generator |
|---|---|
| Salt Level | 2700 - 3400 ppm |
| Cell Type | Turbo Cell |
| Voltage | 120/240V |
| Warranty | 3 years |
To Next Page
