Hayward AquaRite 100 User Manual

Problem Detected with any one of these LED’s illuminated indicates an Internal Error.
Remove power to the AQR100 for two minutes.
Re-apply power to reset the system. If error does not
clear go to step 5B.
Remove Power From the AQR100
Problem Detected: LED #5,6,7, or 9
Step 5A
Test salt level of water, using an independent test, witha
calibrated salt meter. If salt level is above4500,
dilute salt. If fine, go to Step 5C.
Test the Salt Level
Step 5B
Desired Salt
Concentration:
1500-4500 PPM
* Salt Dilution Formula is found on pg. 55 of this manual
Turn power off for 2
mins, then back on
48

Hayward AquaRite 100 Specifications

General

Brand	Hayward
Model	AquaRite 100
Category	Water Pump
Language	English