HCI RM22A - Advanced Setup: Power and USB Operations; USB Clone Functionality; Power On Settings Configuration; LED Control Settings

------------------------------------------------- ------------------------- - RM22A/RM22D OPERATIONS MANUAL
HealthCare Information, LLC 18
USB C lone Stores or reads TV setup using a USB flash drive.
Read Loads TV setup data from a US B drive.
Write Saves TV setup data to a USB drive.
Power On Determines TV setti ngs used when TV is turned on.
Setup
Input Source Sele cts the input source the TV uses when turned on. Selections are:
N one - TV - AV - S - Video - DVD - Component - HDMI - FM - VGA.
N one TV turns on to same source being used at turn off.
TV Rear panel F connecter.
AV Left side audio / video jacks.
S-V ideo Rear panel YC signal input.
DVD Side panel DVD interface.
C omponent Rear panel component audio / video input.
HDMI Side panel high definition multimedia interface.
FM FM Radio.
VGA Rear panel computer monitor input.
Note: The names of these source s can be changed in the source menu .
Ch No. On Set channel TV will tune to when turned on. 000.000 turns on to same channel TV was
on when tur ned off. INPUT SOURCE must be set to TV.
V olume On Sets the turn on volume level the set will use at turn on. If set to 0, volume will be the
same as when set was turned off.
IR B and Sets the IR band for the IR remote control. The IR BAND of the remo te control must be
set to match the TV. Selections are:
Band 1 – Band 2 – Band 3 – Band 4
NOTE: To change the IR band of the IR remote, press and hold the power button on the IR
remote for 10 seconds. The HCI remote can use Band 1 and Band 2. Band 3 and Band
4 are for universal remotes. Off disables the IR receiver. You can use the front panel
left/right arrow buttons to change this selection also.
P ower On Sets power mode of the set. Selection are:
OFF – Mode 1 – Mode 2 – Mode 3
Of f Normal Operation
MODE 1 Set turns on when AC power is applied, can not be turn off.
MODE 2 Set turns on when AC power is applied, can be turned off.
MODE 3 Quick Start, same as OFF but set turns on faster.
LED C ontrol Sets the status of the power LED when the set is on or off. Selections are:
Normal – Reverse – OFF - ALL – OFF -BLK
Normal Power LED is off when the set is on and on when the set is off.
Reverse Power LED is on when the set is on and off when the set is off.
OFF - ALL Power LED is off whether the set is on or off.
OFF -BLK Power LED is off but blinks when the IR Remote Control is working.