• 11
Owner’s Manual
General Operating Instructions:
General Cleaning Instructions:
• Unplug the unit before cleaning.
• Clean after each use.
• Make sure unit has cooled completely prior to cleaning.
• The outer surface may be cleaned by wiping carefully with a damp dishcloth or
sponge.
• Remove the power plug prior to cleaning the NuWave PIC. Do not use caustic
cleaning agents and water should not penetrate the interior of the induction
cooktop.
• Never immerse the PIC, its cables or plug in water or other liquids.
• Wipe the glass surface with a damp cloth or use a mild, non-abrasive soap
solution. Make sure the unit has cooled completely before cleaning.
• Wipe casing and operating panel with a soft cloth dampened with water or a
mild detergent.
• Do not use oil-based cleansing products as their use may damage plastic parts
or the casing/operating panel.
• Do not use ammable, acidic or alkaline materials or substances near the PIC,
as this may reduce the service life of the induction cooktop or pose a re risk
when the induction cooktop is in use.
• In order to keep your PIC looking like new, take measures to ensure that
the bottom of cookware does not scrape the unit’s glass surface, although a
scratched surface will not impair the use of the induction cooktop.
• Make sure to properly clean the unit before storing it in a cool, dry place.
• Place the cooktop on a stable, level, non-metallic surface.
• Never use the cooktop on a ammable surface (e.g. table cloth, carpet, etc.).
• Do not block the ventilation slots of the induction cooktop. This may cause the unit
to overheat. Maintain a minimum distance of 3-5 inches from walls and other objects,
appliances, etc.
• Do not place the PIC next to devices or objects that react sensitively to magnetic
elds (e.g. radios, TVs, video recorders, etc.).
• Do not use the induction cooktop in the proximity of open res, heaters or other heat
sources.
• Ensure that the power cable is not damaged or compressed beneath the induction
cooktop.
• The power cable must not come into contact with sharp edges and/or hot surfaces.
• Prior to connecting the PIC, conrm that the voltage needs indicated in this manual
correspond to the voltage supply in your home. A wrong connection may lead to the
unit’s damage and possible injury to persons.
• The cooktop’s surface is designed from temperature-resistant glass. In the event
that damage to the unit is observed, even a small crack on the glass surface,
immediately disconnect the PIC from the power supply.
IMPORTANT TIPS:
1. Check power outlets to ensure proper operation. Do not use in an outlet
where other major appliances are engaged. Check settings if the unit is
cooking too slowly.
2. The electrical plug must be properly plugged into the outlet.
3. Always turn off and unplug the unit before wiping.
• 11
To Next Page
Loading...