Heat Controller A-VFH24TA-1 - Outdoor Unit Subassembly and Clearance Details; Subassembly Part Numbers and Installation Clearance

14
VFH InverterFlex
®
- Outdoor Ductless Mini-Split Heat Controller
Part #
Flare Nut Size ①
Flare Fitting ②
Length L1
Length L2
06654110 1/4” (6.35mm) 3/8” (9.52mm) 3.11” (79mm) 3.5” (88mm)
06654111 1/2” (12.7mm) 3/8” (9.52mm) 4.45” (113mm) 4.65” (118mm)
06654112 1/2” (12.7mm) 5/8” (15.9mm) 4.45” (113mm) 4.85” (123mm)
06654113
3/8” (9.52mm)
1/4” (6.35mm)
4.37” (111mm)
5.55” (141mm)
06654114
5/8” (15.9mm)
3/8” (9.52mm)
6.92” (176mm)
6.50” (165mm)
06654120 5/8” (15.9mm) 1/2” (12.7mm) 6.92” (176mm) 5.24” (133mm)
06554121* 3/8” (9.52mm) 1/2” (12.7mm) 4.37” (111mm) 3.74” (95mm)
*Note : This subassembly only comes with the A-VFH42PA-1 model.
IMPORTANT: Due to the use of these subassemblies on the connections of the outdoor unit, please be
sure to accommodate for about 9” (220mm) of clearance from the side of the unit where the refrigerant
lines attach.
Subassemblies for A-VFH24TA-1, A-VFH30QA-1 Outdoor Units:
For models A-VFH24TA-1 and A-VFH30QA-1, two (2) subassemblies consisting of a straight piece of copper with a female
flare nut x male flare fitting, are provided to connect any indoor units that have 1/2” (12.7mm) gas connections with the
outdoor unit’s 3/8” (9.52mm) gas connections.
① Flare Nut
Connects to Outdoor Unit
②
Flare Fitting w/Cap
Connects to Line Set
Unit Length
Additional Clearance
Required
≈ 9” (220mm)
L1
L2
Top View