11
Heat Controller, Inc. VCH SerieS Owner’s Manual
Push this button to
change the swing
angle of louver.
Push this button to
set the economical
operation mode.
Push TIMER ON
timer button to set
the ON timer.
Push TIMER OFF
timer button to set the
OFF timer.
This button is used
for setting the time.
Push this button to
cancel or exit setting the
ON timer and OFF timer.
Push this button to
activate the horizontal
swing function.
Hold button more than
2 seconds to activate
the vertical swing
function.
Push this button to
confirm on/off timer
settings.
Push this button to
set time.
Use the lock mode
when you want to prevent
preprogrammed settings from being
changed. Push the LOCK button
again when you want to cancel the
LOCK mode. In lock mode, no other
buttons will work.
Deletes all custom settings
and reverts back to factory
programmed settings.
The remote controller above drawing may have some differences
from the one that you purchase.
Air Direction button
Economy running button
ON/OFF
timer button
Time adjust button
Cancel button
Reset button
Swing button
Ok button
Clock button
Lock button
AUTO COOL DRY HEAT FAN
TEMP
CLOCK
TIMER ON
TIMER OFF
SPEED
AUTO LOW MED HIGH
MODE
ON
OFF
TEMP.
FAN
SPEED
AIR
DIRECTION
SWING
CLOCK
ECONOMIC
RUNNING
TIMER ON
TIMER OFF
TIME ADJUST
OK
CANCEL
2
AUTO COOL DRY HEAT FAN
TEMP
CLOCK
TIMER ON
TIMER OFF
SPEED
AUTO LOW MED HIGH
MODE
ON
OFF
TEMP.
FAN
SPEED
AIR
DIRECTION
SWING
CLOCK
ECONOMIC
RUNNING
TIMER ON
TIMER OFF
TIME ADJUST
OK
CANCEL
1
3
4
2
When you select the timer operation, the remote controller automatically
transmits the timer signal to the indoor unit at the specified time.
Therefore, keep the remote controller in a location from which it can
transmit the signal to the indoor unit properly.
The effective operation time set by remote controller is limited in 24 hours.
1. ON / OFF TIMER button
Push the ON or OFF TIMER button as
required. The current timer setting is
displayed along with ON/OFF TIMER
indicator, and the colon in the timer
setting will flash.
2. Time adjust button (TIME ADJUST)
Push to set the desired time.
Forward
Backward
Each time you push the button the time
moves forward or backward by 10 minutes
depending on which one you push.
3. OK button (OK)
Push this button. Check the TIMER lamp
on the display panel of the indoor unit is lit.
4. Cancel button(CANCEL)
Push the CANCEL button to cancel the timer
setting.
Preform steps 1, 2 and 3 to change the setting.
Canceling
Changing
.
.
F
TIMER OPERATION
BUTTONS AND THEIR FUNCTIONS
CAUTIONS
To Next Page
Loading...
