Heat Controller B-VCH12FC-1 - Setting the Clock on the Remote

7
Heat Controller, Inc. VCH SerieS Owner’s Manual
Before you start operating the air conditioner,
set the clock of the remote controller using
the procedures given in this section. The
clock panel on the remote controller will
display the time regardless of whether the
air conditioner is in use or not.
When batteries are inserted in the remote
controller, the clock panel will display "0:00"
and the colon will flash.
1. Time adjust button (TIME ADJUST)
Push this button to set time.
Forward.
Backward.
Each time you push the button, the time
moves forward or backward by one minute
depending on which side you Push.
Initial Setting of the Clock
When replacing batteries, do not use old batteries or different brands
batteries, otherwise it may cause the remote controller to
malfunction.
If you do not use the remote controller for a few weeks or more,
remove the batteries. Otherwise, battery acid leakage may damage
the remote controller.
The average battery life during normal use is approximately half a
year. Replace the batteries when there is no receiving beep from
the indoor unit or if the transmission indicator on the remote
controller fails to light.
.
AUTO COOL DRY HEAT FAN
TEMP
CLOCK
TIMER ON
TIMER OFF
SPEED
AUTO LOW MED HIGH
MODE
ON
OFF
TEMP
FAN
SPEED
AIR
DIRECTION
SWING
CLOCK
ECONOMIC
RUNNING
TIMER ON
TIMER OFF
TIME ADJUST
OK
CANCEL
2
3
1
.
.
5
1. Use the lock mode when you want to
prevent settings from being changed.
Push the LOCK button again when you
want to cancel the LOCK mode.
AIR
DIRECTION
SWING
OK
CLOCK
TIME ADJUST
21
CANCEL
ECONOMIC
RUNNING
TIMER ON
TIMER OFF
2. When you push the RESET button,
all current settings are cancelled and
the remote defaults back to the factory program.
.
.
Clock
When you push the OK button, the clock time
display stops flashing and the clock starts
operating.
Push the CLOCK button in the battery
compartment, the colon in the clock display will
start to flash.
To set the new time, follow 1 and 2 of "Initial
Setting of the Clock".
*Clock accuracy is within 10 seconds per day.
2.OK button.
3.Readjusting the Clock
Static electricity or other factors (in case of extremely high voltage) can
cause remote controller clock initialize. If your remote controller is
initialized (flashing of the colon in "0:00"), readjust the clock before you
start operation.
F
CAUTIONS
LOCK AND RESET BUTTON FUNCTION
NOTES
SETTING THE CLOCK