Heath Zenith 5610 - User Manual

© 2015 HeathCo LLC
Motion Sensor
Entryway Light
Models 5610/15
The Heath
®
/Zenith Motion Sensor Entryway Light turns
on up to 60 watts of incandescent light when motion
is detected and then, after a selectable time period,
automatically turns the light off. The built-in photocell
keeps the light off during daylight hours.
Sensor
Entryway Light
Mounting Nut and Stem
2 Wire
Connectors
2 Screws
Mounting Strap and
Grounding Wire
globe
(5615)
or
jar
(5610)
Requirements
• The Entryway Light requires 120-volts AC.
• If you want to use Manual Override, the light must be
wired through a switch.
• Some codes require installation by a qualified
electrician.
This package includes:
OPERATION
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
1
/
2
minutes for
the circuitry to calibrate.
MANUAL MODE
ON-TIME
10 5 1 TEST
10 5 1 TEST
ON-TIME
TEST
... back on.
AUTO
1 Second
OFF then...
Put the ON-TIME switch in the
1, 5, or 10 minute position.
Put the ON-TIME switch on the bottom
of the sensor in the TEST position.
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 10
position.
Move ON-TIME Switch to
1, 5, or 10 minutes
Mode Switching Summary
Flip light switch off
for one second then
back on*
MANUAL MODE
AUTO
TEST
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the cali-
bration time the control will be in the AUTO mode.
Mode: On-Time Works: Day Night
Test
5 Seconds x x
Auto
1, 5, or 10 Minutes x
Manual
Until Dawn* x

Summary

Operation

Mode Switching Summary

Summarizes how to switch between TEST, AUTO, and MANUAL modes using the light switch and ON-TIME setting.

Installation

Test and Adjustment

Guides on setting up the sensor's sensitivity (SENS) and time delay (ON-TIME) controls for optimal performance.

Aiming and Coverage

Specifications

Provides technical details like range, load capacity, power requirements, operating modes, time delay, and sensitivity.

Troubleshooting Guide

Heath Zenith 5610 Specifications

General

Voltage	120 V
Adjustable Head	Yes
Weather Resistance	Yes
Type	Motion Sensor
Power Source	Wired
Light Source	LED
Sensor Range	70 ft
Mounting Type	Wall