To Next Page

Type “D”

This package includes (Style of push button and chime may vary from illustration):

• Wirelesschime

• Wirelesspushbuttonwithbattery(Specicmodelsinclude2)

• Hardwarepack

This chime requires 3 “D” alkaline batteries (not included). In typical use,

alkalinebatterieswilllastuptothreeyears.

6180 Series, 6270 Series,

and 6280 Series

Decorative Wireless

Chime

Cover Mounting Tabs

Chime

Volume

Jumpers

Figure 1

WARNING: To prevent possible

SERIOUS INJURY or DEATH:

• NEVER allow small children near

batteries.

• If battery is swallowed, immediately

notifydoctor.

1. InstallalkalinetypeA2312voltpushbutton

battery(included). Remove back of case by

pushingintabonbottomwithasmallscrew-

driver(seeFigure1).Seediagraminsidepush

buttonforcorrectbatteryorientation.Note: If

batteries are preinstalled, remove orange

batterytab.

2. Install 3 alkaline “D” batteries. Make sure

batteriesareorientedproperly(seeFigure2).

3. Test range. Temporarily position chime and

pushbuttonwhere youwantit mounted.

Press push button to verify chime and push

button work properly. If chime does not

sound, see Troubleshooting.

4. Adjust volume control. Adjust volume control

todesiredvolume(seeFigure2).

Figure 2

Heath Zenith 6180 Series User Manual

Other manuals for Heath Zenith 6180 Series