Why does my Heath Zenith Wireless Strobe Chime 6144 Accessories chime keep going off?
If your Heath Zenith Accessories chime is sounding when it's not supposed to, it might be getting interference from another wireless device. Try changing the code setting to resolve this issue.
What to do if Heath Zenith Wireless Strobe Chime 6144 Accessories chime doesn't work after installing batteries?
If the batteries seem fine but your Heath Zenith Accessories chime and strobe aren't working after installation, it could be due to mounting issues. Avoid mounting the chime or push button on metal or near metal studs, as this reduces the transmitter range. Use 1/4" to 1/2" (6 to 13 mm) wood shims to move the chime or push button off the metal surface. Also, concrete floors may reduce the range, so try moving the chime away from the floor. You might also want to try locating the chime closer to the push button.
How to fix a Heath Zenith Wireless Strobe Chime 6144 Accessories chime that doesn't sound?
If your Heath Zenith Accessories chime isn't sounding and the strobe isn't flashing, make sure the push button and chime codes are the same. Also, check the orientation of the push button battery, referring to the diagram inside the push button for correct placement. Finally, check the charge of the push button battery and replace it if necessary.
Ensure push button and chime codes match and check push button battery orientation and charge.
Chime may be receiving interference; change the code setting on the push button and chime.
Avoid mounting on metal and use wood shims to move device off metal surfaces; consider chime placement.
General| Type | Wireless Strobe Chime |
|---|---|
| Model Number | 6144 |
| Power Source | Battery |
| Visual Alert | Yes |
| Strobe Light | Yes |
| Chime Sounds | Multiple |
| Color | White |
| Features | Strobe light |
| Range | Up to 100 feet |
| Wireless Range | Up to 100 ft |
| Operating Frequency | 433 MHz |
| Voltage | 3V |
| Frequency | 433 MHz |
| Mounting Type | Wall Mount |
To Next Page