Heath Zenith Wireless Musical Chime SL-6164 User Manual

© 2007 HeathCo LLC 595-5707-05
Your doorbell includes:
• Doorbell chime
• Doorbell button/transmitter w/battery
• Hardware pack
You'll need to buy 3 "D" alkaline batteries for the chime. In typical use,
alkaline batteries will last up to three years.
3. Before mounting, test the doorbell range. Put the
chime where you want to mount it and temporarily
place the doorbell button on the doorjamb. Press the
doorbell button.
2. Install the 3
alkaline "D"
b a t t e r i e s .
Make sure
the batteries
are oriented
properly.
Operation
Press the doorbell button to verify that the doorbell and chime work prop-
erly. If the chime does not sound see the Troubleshooting guide on page 5.
Model SL-6164
Wireless
Musical
Chime
1. To open the chime case:
Press in both catches on
the bottom of the chime
and lift the case open.
Battery
Battery
Battery
Chime Volume
4. Mount the doorbell button and chime.
Use either screws or double sided tape to mount the doorbell button.
To mount with screws, remove the back of the case by lightly pushing in the tab
on the bottom with a small screwdriver and rotating the blade.
Attach the back of the case to the
door jamb or wall. Snap the front
of the button back on.
When attaching the doorbell but-
ton using the double sided tape,
make sure the surface of the door
jamb or wall is clean.

Heath Zenith Wireless Musical Chime SL-6164 Specifications

General

Brand	Heath Zenith
Model	Wireless Musical Chime SL-6164
Category	Accessories
Language	English

Summary

Operation

To open the chime case

Instructions on how to open the chime case by pressing the bottom catches.

Install batteries

Guide for correctly installing three 'D' alkaline batteries into the chime unit.

Test doorbell range

Steps to test the doorbell range by temporarily placing the button on the doorjamb before permanent mounting.

Mount doorbell button and chime

Methods for mounting the doorbell button using screws or double-sided tape.

Music Selection

Slide Switch

Explanation of the slide switch and song selection jumper for choosing tunes.

Code Settings

Doorbell Button Battery Replacement

Instructions for replacing the doorbell button's A23 12 Volt battery, noting positive terminal orientation.

Code matching requirement

Requirement for code settings 1-7 to match on both doorbell button and chime.

Troubleshooting

Chime does not sound

Steps to troubleshoot when the chime does not sound, including code and battery checks.

Chime not working after installation

Troubleshooting advice for when batteries are fine but the chime fails to operate after installation.

Limited Warranty

Warranty coverage and exclusions

Details what the five-year limited warranty covers and lists exclusions like misuse and consequential damages.