Heath Zenith SL-7464-03 User Manual

This chime requires 3 “C” alkaline batteries (not included). In typical use,
alkaline batteries will last up to 2
1
/
2
years.
Wireless Chime
© 2017 HeathCo LLC
Figure 1
WARNING: To prevent possible
SERIOUS INJURY or DEATH:
• NEVER allow small children near
batteries.
• If battery is swallowed, immediately
notify doctor.
This package includes (Style of door sensor and chime may vary from illustration):
1. Remove orange battery tab from push
button. Remove back of case by pushing in
tab on bottom with a small screwdriver (see
Figure 1). Remove orange battery tab.
2. Install 3 alkaline “C” batteries (not includ-
ed) into chime base. Make sure batteries are
installed according to the diagram inside the
chime (see Figure 2).
IMPORTANT: To avoid resetting chime base
memory, wait 30 seconds before pressing
push button. See Troubleshooting, Problem
3 if chime memory was accidentally reset.
C
H
I
M
E
V
O
L
U
M
E
3x - “C” TYPE BATTERIES
TYPE “C”
TYPE “C”
TYPE “C”
PRESS & HOLD TUNE–1 SEC SYNC–3 SEC RESET–10 SEC
Figure 2
Chime base Chime cover Wireless push
button
Hardware
pack
Model
C
H
I
M
E
V
O
L
U
M
E
3x - “C” TYPE BATTERIES
PRESS & HOLD TUNE–1 SEC SYNC–3 SEC RESET–10 SEC
7611
✔ ✔ ✔ ✔
7464
✔ ✔ ✔ ✔

Heath Zenith SL-7464-03 Specifications

General

Brand	Heath Zenith
Model	SL-7464-03
Category	Accessories
Language	English

Summary

Safety Warnings

Battery Safety

Warning to prevent injury or death: never allow small children near batteries or if swallowed.

Installation and Setup

Battery Installation

Remove battery tabs and install 3 'C' alkaline batteries into the chime base.

Mounting the Push Button

Mount the push button using screws or double-sided tape.

Mounting the Chime Base

Prepare the chime base cover pin and mount the base securely to the wall.

Tune Settings

Changing Chime Tunes

Instructions to select between Ding, Ding-Dong, or Westminster tunes using the chime base jumper.

Troubleshooting

Chime Not Sounding

Solutions for when the chime does not sound or quits after one ring.

Chime Not Working After Installation

Troubleshoot issues when the chime doesn't work post-installation, checking mounting and range.

False Triggers

Corrective actions for unintended chime activation due to interference.