Why do my Heath Zenith 5316 Accessories lights come on for no apparent reason?
Your Heath Zenith Accessories lights might be activating due to small animals or automobile traffic triggering the sensor; try re-aiming the sensor. Also, the sensitivity might be set too high, so reduce it. Additionally, ensure the DualBrite® Timer is turned off.
Why do my Heath Zenith Accessories lights come on in daylight?
Your Heath Zenith Accessories light control might be installed in a dark location; try repositioning it. Alternatively, the light control may be in 'Test' mode; set the control switch to an ON-TIME position.
Why do my Heath Zenith 5316 Accessories lights stay on continuously?
Your Heath Zenith Accessories lights might stay on because a lamp is too close to the sensor, or pointed at nearby objects causing heat to trigger the sensor; reposition the lamp away from the sensor or objects. Alternatively, the sensor could be pointed toward a heat source like an air vent, so try repositioning the sensor. Also, ensure the light control is switched to 'Auto' and not in 'Manual Mode'.
What to do if my Heath Zenith 5316 Accessories lights will not come on?
If your Heath Zenith Accessories lights won't turn on, first ensure the light switch is on. Then, check the bulb to see if it's loose or burned out and replace it if necessary. Also, check the fuse and circuit breaker. If it's daytime, the daylight turn-off feature might be active, so recheck after dark. For new installations, verify the circuit wiring. You may also need to re-aim the sensor to cover the desired area.
Why are my Heath Zenith 5316 Accessories lights flashing on and off?
The flashing of your Heath Zenith Accessories lights could be due to heat or light from the lamps turning the light control on and off; reposition the lamps away from the sensor. It could also be caused by heat being reflected from other objects; try repositioning the sensor. If the light control is in 'Test' mode and warming up, this flashing is normal; turn Boost off.
Why do Heath Zenith Accessories lights turn off too late in Dusk-to-Dawn setting?
The sensor of your Heath Zenith Accessories might be in a relatively dark location. Try relocating the sensor, or use the 3 hr or 6 hr setting.
What to do if Heath Zenith 5316 lights flash once, then stay off in Manual Mode?
If your Heath Zenith Accessories lights flash once and then stay off in Manual Mode, it might be because the sensor is detecting its own lights. Reposition the lamps to keep the area below the sensor relatively dark.
Highlights include automatic lighting, DUALBRITE® timer, photocell, and motion detection LED.
Specifies compatibility with 120-volt AC, exclusion of fluorescent lights, and wiring for Manual Mode.
Explains the TEST, AUTO, and MANUAL modes and the DUALBRITE® timer functionality.
Provides specific steps for rotating the sensor head when mounting on eaves.
Details the process of connecting sensor wires to the light control using wire connectors.
Instructions on physically attaching and adjusting the light fixture and sensor.
Guides on adjusting the sensor's aim for optimal coverage and avoiding false triggers.
Details the maximum sensing range and coverage angle of the motion sensor.
Instructions for setting ON-TIME, DUALBRITE® timer, and summary of product specifications.
Addresses various symptoms like lights not turning on, staying on, or flashing unexpectedly.
Provides contact details for technical support and outlines the two-year limited warranty.
General| Brand | Heath Zenith |
|---|---|
| Model | 5316 |
| Category | Accessories |
| Language | English |
To Next Page