Heathkit AR-14 - Page 12

Page 8
START
•
NOTE: Capacitors and a choke will
be installed on the right-hand side
of the circuit board in the following
steps. Capacitors will be called out
by capacitance value and the type of
capacitor only,
150 µµf mica.
H- 470 µµf mica.
~ O µfd electrolytic, Position the
positive (+) lead as shown,
POSIT~E Jri
,',:;,;:;~]Iiif/Y •·
( ) Set aside the .01 µfd 1,6 KV
disc ceramic capacitor, so it
will not be installed by mis-
take with the ,01 µfd disc ca-
pacitors.
) .01 µfd disc ceramic,
·-:-:.-_:_:;:-;:
POSITIVE ·
r+i
END
~ 10 µfd
· · ill ion
shown.
( ) Solder all leads and clip off the
excess lead lengths,
I
~fft&i=fHirJ
CONTINUE
Q
.. ., ; :::iii
··1 : } ···•·•·•·•·•·
~ 1 µfd disc ceramic.
.01 µfd disc ceramic.
,n .01 µfd disc ceramic.
iij --~ ........... : .... 1...... ....... 1===:=:=: =:=:=:=:=:=:=:=:=:=:=:=:=:=:=:=====I
:;:
.::
PICTORIAL 3
6,8 µµf disc ceramic.
.01 µfd disc ceramic.
.01 µfd disc ceramic.
270 µµf disc ceramic.
270 µµf disc ceramic,
90 µh choke (#45-7).
10 µfd electrolytic, 10 V.Posi-
tion the positive (+) lead as
shown,
680 µµf mica.
,01 µfd disc ceramic,
Solder all leads and clip off the
excess lead lengths.
PROCEED TO PICTORIAL 4.