Heathkit AR-14 - Page 13

~ff·MiffHf@
START
• NOTE: Capacitors and packaged e-
lectronic circuits (PEC) will be in-
stalled on the left-hand side of the
circuit board in the following steps.
( { .002 µfd disc ceramic.
( ~ fd electrolytic, 10 V. Posi-
tion the positive (+) lead as
shown.
N-P EC (#84-36). Insert the num-
bered leads in the numbered
holes as shown.
r~
I ,
3
( ...l..-.,.00 1 µfd disc ceramic.
i-,,--1- ,41.L µfd disc ceramic.
( "1-.- 01 µfd disc ceramic.
NOTE: The resin capacitors are
marked with a band on one end,
However, this can be disregarded
when installing the capacitors.
.2 µfd resin .-
390
N 10 µfd electrolytic 12 v. Position
~ positive (+) lead as shown.
~ mica.
Solder all leads and clip off the
excess lead lengths.
PICTORIAL 4
,
I
Page 9
CONTINUE
Q
.002 µfd disc ceramic.
( -....l..!,9 µfd electrolytic, 10 V. Po-
sition the positive (+) lead as
shown.
( d PEC (#84-36). Insert the num-
' bered leads in the numbered
holes as shown.
.01 µfd disc ceramic •
• 01
µfd resin.
.01 µfd resin.
tubular,
( ) Solder all leads and clip off
the excess lead lengths.
PROCEED TO PICTORIAL 5.