Heathkit AR-14 - Page 15

l§ ~ fff&iffHi@
START
•
NOTE: Transformers and coils will
be installed on the circuit board in
the following steps. Solder the leads
after each component is installed.
It is not necessary to cut off the
lugs after soldering.
IF transformers (#52-81) at T3.
4, and T5. Match the side of the
tr sforme r that has the widely
spaced pins with the wide-spaced
holes of the circuit boar d.
,",":i' -3 & 1!/JJ.
... . ;,t:);'i rti/J, Je\Yi""'
Ratio detector transformer (#53
at T6. Insert the transformer
N ::::~~:::f:::f ~::: ,-----fl+!;· l· *· ·iJJ ··· s != w i= 11 === £ ~-: ~ 11111 11
· ~ t T7. Position the coil with
its color dot as shown.
( )
Remove two lugs from the 38 kc
trap coil (#40-556) as shown.
Then install this coil on the
circuit board at LB.
RE MOVE
LUGS
CONTINUE
V
19 kc tank coil (#40-543) at L7.
67 kc trap coil (#40-697) at L6.
FINISH
Set the circuit board aside and pro-
ceed to Pictorial 7.
PICTORIAL 6
Page 11