Heathkit AR-14 - OPERATION; Front Panel Controls Overview

J
2
Page 46
Figure 2
Figure 2 shows how the speakers, antenna, tape
recorder, and phonograph are connected to the
rear panel of the Receiver.
( ) Speaker connections should be made using
good insulated wires such a~ lamp cord.
Install the spade lugs supplied with this kit
on the ends of the speaker wires, as shown
in
Figure 3.
CRIMP AND
~
~ :::::
Figure 3
I
( ) Connect one wire of your left speaker syste
under the head of the COM connecting sere
of
the LEFT SPEAKER output terminal. Co
nect the other left speaker wire to th~ re
maining LEFT SPEAKERconnectingscrew
regardless of your speakers impedanc
( )
Similarly, connect one wire of your righ
speaker system to the COM connecting sere
of
the RIGHT SPEAKER output termina
Connect the other right speaker wire to th
other RIGHT SPEAKER connecting screw
regardless of your speakers impedance
NOTE: When
installing the Receiver, the speake
wires must be ungrounded and no connectio
should be made between the left and right speake
systems.
'!