NOTE: When installing prepared cables, apply
only enough heat to make a good solder con-
nection. Excessive heat will melt the insula-
tion on the wires.
(
&"At the end of this prepared cable with the
short white wire, connect the white wire
to solder lug
K
(S-1).
Connect the remaining wires from this end of
the prepared cable to terminal board C as fol-
lows. Be sure all the small wire strands of
each wire go into the terminal board lugs.
(J)
Black to lug
8
(S-1).
(
.
)
Brown to lug 4 (S-1).
(
)
Yellow to lug
7
(S-1).
(,
)
Green to lug
3
(S-1).
(
4
Red to lug 2 (NS).
(
4
Blue to lug
5
(S-1).
(
4
Orange to lug
1
(S-1).
Position the circuit board along the side of the
cabinet top as shown. Connect the wires from
the other end of the prepared cable to the cir-
cuit board as follows.
/
fi/$
Black to hole C (S-1).
(
.-(Red to hole
E
(s-1).
(4
Green to hole
D
(S-1).
(A
White to hole
G
(S-1).
(
Yellow to hole B (S-1).
('T
Orange to one of the holes at
H
(S-1).
(/(~lue to hole
K
(S-1).
(-3/'~rown to one of the holes at R (S-1).
(+deferring to Detail 5B, prepare a 14"
length of 4-wire cable as shown.
(
fAt the end of the prepared cable with the
short white wire, connect the
blackand white
wires to solder lug
J
(S-2).
Connect the remaining wires at this end of the
cable to terminal board C as follows.
(
7
Green to lug
6
(S-1).
(
-)
Red to lug
2
(S-2).
The other end of the cable will be connected later.
-2-
1
/4"
RED
WHT 2-1/4"
2-
114'
BLK
2-1/4"
GRN 1
-3/4"
RED
I-1/4"
4-
WIRE
CABLE
GRN 1-1/4"
Detail
SB
To Next Page
Loading...
