4-
WIRE
CABLE
RIGHT-HAND OPERATIO
Detail
1OA
Right-
Hand
Operation
Refer to Detail
10A
for the following steps.
(
)
Install the plastic paddle handles on the key
lever. Use
6-32
x
3/8"
hardware
in
the
hole furthest from the end of the key lever.
Align
the
other holes of the paddles andkey
lever, and tighten the screw.
(
)
Install the key knob in the end hole
of
the
key lever, using a
6-32
x
1/2"
self-tapping
screw. Do not overtighten the screw as the
threads can be stripped from the knob.
Position the knob as shown.
Connect the free ends of the wires
coming
from the 4-wire cable, to switches
R
and
S
as follows.
(
)
White to lug
2
of switch
R
(S-1).
( )
Green to lug
1
of switch R
(S-1).
(
)
Black to lug
2
of switch
S (S-1).
(
)
Red
to
lug
1
of switch
S
(S-1).
(
)
Position the cable wires as shown.
To Next Page
Loading...
