Page
10
W
IRING-CABINET
TOP
Refer to Pictorial
5
(fold-out from Page
11)
for the following steps.
(k,'
Bend lug
5
of switch
H
against the switch
frame
(S-1). See the inset drawing on Pic-
torial
5.
NOTE: After the neon lamp
is
wired in the
following steps, be sure the leads of the lamp
do not touch each other in the base of the lamp.
(
Place a 3/4" length of sleeving on one lead
'
of neon lamp
G.
Pass the end of this lead
through lug
1
of switch
H
(S-2). Do not cut
o,ff this lead.
i
I
(4
Place a 1/2" length of sleeving on this
same neon lamp lead. Then connect this
l~ad to lug
3
of switch
H
(NS).
6'
(of
Place a 3/4" length of sleeving on the
other lead of neon lamp
G.
Connect this
lead to lug
4
of switch
H
(NS).
NOTE:
In
the following two steps, do not wrap
the leads of the fuse around the switch lugs.
Position the fuse as shown in the inset drawing
on Pictorial 5. Be sure the body of the fuse
does not touch the cabinet top.
>,/'
(W.
Locate the 1/8 ampere fuse. Cut one lead
to
7/8"
and the other to 1/2". Place a 5/8"
length of sleeving on the longer lead and
yonnect it to lug
2
of switch
H
(S-1).
(
'-/place a 1/4" length of sleeving on the
other lead of the fuse, and connect it to
lug 8 of switch
H
(NS).
NOTE: When preparing the cables in
thefollow-
ing steps, remove the outer insulation and cut
the wires at each end of the cable as specified.
Then strip
1/4" of insulation from each wire.
Twist the small wires together and melt a small
amount of solder on the exposed wire ends to
hold the small strands together.
(4'~eferrin~ to Detail
5A,
prepare a
9-1/2"
length of 8-wire cable as shown.
GRN 2-3/4"
YEL 2-1/2"
ORG 2-1/2"
GRN I-1/2" WHTZ-1/4"
RED 1-3/4"
WHT 1/2"
TAKING CARE NOT TO CUT THE INNER LEADS REMOVE THE INNER INSULATION. THEN APPLY
REMOVE THE OUTERINSULATION OF THE CABLE. SOLDER TO THE ENDS OF THE INNER LEADS.
9
h
Detail
5A
To Next Page
Loading...
