FLAT SIDE
\
L
Detail
7Ei
/e-*d
(
)
Referring to Detail
7B,
cut
the
leads of the
three 2N2712 transistors to 3/16", Install
these transistors in sockets
Q3,
Q6,
and
Q11.
Note flat side of transistor.
4d'
(
)
Referring to Detail 7C, bend and position
the center lead of the 2N398A transistor
as shown.
Cut
all three leads to 3/16".
Install the transistor in socket
Q8.
Check to see that none of the transistor socket
solder connections were pulled loose from the
circuit board when the transistors were installed.
Temporarily, set the cabinet top and circuit board
assembly aside.
KEY-MECHANICAL ASSEMBLY
Refer to Pictorial
8
on Page l6for the following
steps.
Locate the ballast plate and position it on the
work area as shown.
64)'
Referring to Detail
8A,
install the 3/4" OD
shoulder spacer at
M.
Use a 10-32
x
1/2"
screw and three 3/4" OD flat washers. Do
not tighten the screw at this time.
(&dstall switch brackets at N and P, using
6-32
x
1/4" screws. Position the brackets
as shown. Push them as far as possible to-
ward the outside of the ballast plate. Tighten
the screws just enough to hold the brackets
in place. They will be readjusted later.
ERE
BEND CENTER LEAD
OVER LOCATING TAB.
LOCATING TAB
BEND CENTER LEAD
UP
KEEPING IT IN LINE WITH.
BUT NOT TOUCHING THE
OTHER TWO LEADS.
3/4" OD SHOULDER
SPACER
3/4" OD FLAT
6-32x 1/4"
SCREW
h
@
10-32xV2" SCREW
PUSH OUTWARD AS FAR AS POSSIBLE
IN DIRECTION OF ARROW.
Detail 8A
To Next Page
Loading...
