@6-32
NUT
f9M
LOCKWASHER
PICTORIAL
10
FINAL
WIRING
NOTE:
The following steps
are
in two specific
Refer to Pictorial
10
for the following steps.
groups. One group
is
for right-hand operation.
and the other group is for left-hand operation:
Use the group of steps for the desired type
(
)
Install
the
ballast plate assembly to the
OP
Operation.
cabinet bottom. Use 6-32
x
5/8"
hardware
and
rubber feet at locations
T
and U. Be
(
)
Position the cabinet top and
the
cabinet
sure the other holes of the ballast plate
bottom assembly next to each other as
and cabinet bottom are lined
up
properly.
shown in Detail
10A.
To Next Page
Loading...
