1
PLATE,
I
(-
)
Referring to Detail
8B,
install an SPST
snap switch at
R
on switch bracket
N.
Use
2-56
x
3/8"
screws and
2-56
nuts. The
wide spaced lugs go to the top. Push the
switch toward the outside of the ballast
plate as far as possible. Tighten the screws
/just enough to hold the switch in place.
(
j'
In
a like manner, install an
SPST
snap
switch at S on switch bracket
P.
Use
2-56
x
3/8"
screws and
2-56
nuts. Push the
switch toward the outside of the ballast
plate as far as possible. Tighten the screws
just enough to hold the switch in place.
PUSH OUTWARD
AS FAR AS POSSIBLE
IN DIRECTION
OF ARROW
Detail
8B
Refer, to Detail
8C
for the following steps.
(
Astall the flat spring on
a
switch bracket,
using
3-48
x
5/16"
hardware. Be sure to
position the holes of the spring as shown.
Align the top of the spring with the top edge
of the bracket and tighten the hardware.
(:
),
Install the key lever on the flat spring
using
3-48
x
5/16"
hardware in the two
1
holes nearest the switch bracket. Be sure
all the holes in the key lever line up with
the holes of the spring. Align the top edge
of the key lever with the top of the spring
and tighten the screws just enough to hold
the key lever in place.
e"')
Install the two leaf springs on the key lever,
using
3-48
x
5/16"
hardware. Position the
springs as shown andtighten the screws just
enough to hold the springs in place.
Refer to Pictorial
8
for the following steps.
(&istall the key lever assembly on the ballast
plate with the switch bracket at
L
using
6-32
x
1/4"
screws. The leaf springs must
be
outside the shoulder of spacer washer
M
as shown in the inset drawing of Pictorial
8.
The key lever must
be
between switch
brackets
N
and
P.
Tighten the screws just
enough to hold the bracket
in
place.
To Next Page
Loading...
