Heathkit IO-4205 - Page 65

~ 10: Refer to Detail4-1G and mount the DPDT
120V-240V
slide switch on the bottom of the
chassis at location SW10 with 6-32 X 3/16"
screws. Be
sure the switch is positioned so the
lugs with the bare wire between them is toward
the front of the chassis.
~ 6- 32 X 3/16"
~
BARE WIRE
Detail4-1G
Refer to Detail 4-1H and mount the fuse block
on the bottom of the chassis at location F1 with
; -32 x 3/8" hardware.
( ..{ Refer
to Detail4-1J and mount a CRT (cathode
ray tube)
bracket on the top of the chassis at
either of the V1 locations. Use 6-32 x 3/8"
;h ardware.
( .!]' In the same manner, install the other CRT
; bracket
at the remaining V1 location .
I
f
Install a 6-32 push-on nut on the top of each
CRT bracket. Be sure that the flat side of each
nut is up and that each nut is positioned as
shown on Pictorial 4-1.
Page
63
Detail4-1H
I CRT BRACKET I
@ @ 6-32 NUT
~ \\
~/ ~@#6 LOCKWASHER
0
n 6-32 x 3/8"
® ® SCREW
Detail 4-lJ