Heatilator ECOCHOISE CAB50-C - Quick Start Guide

6 August 23, 20197074-801C
HEATILATOR ECO CHOICE CAB50
C. Quick Start Guide
ECO CHOICE QUICK START GUIDE
*Before you plug in this appliance, follow these instructions*
Once a  re has been established in
the unit, leave the unit burning on the
“high” setting for 30 minutes to allow
the paint to cure.
Note: Odors and vapors will be
released during this process.
*Open windows in the room for ven-
tilation*
1
2
4
5
6
9
Remove hang tags from the door glass. Clean the glass. Remove the hardware pack and dessicant
bag from the  rebox area before your  rst  re.
Add pellets to the hopper and close
the lid.
Open the  rebox door and make sure
the ba󰀪 es are in place.
Close the  rebox door and plug the
power cord into the wall receptacle.
Turn the thermostat on.
Turn the thermostat to o󰀨 .
If the feed tube is empty or this is the
 rst  re, add a handful of pellets to
the  repot.
*Do not add extra fuel to the  repot
if the feed tube has already been
primed. Over lling the  repot will
cause smoky start-ups.
If the  re dies out after a few minutes
of operation it will be necessary to
push the reset button to add more
fuel.
3
7
The stove will feed pellets for a
minute and stop. Once a  re starts,
the feed cycle will resume.
Note: Allow 5 minutes for
ignition to take place.
8
After 30 minutes have passed, turn the thermostat o󰀨 and allow the unit to cool completely. Open the door and clean the
 repot according to the cleaning instructions found inside the hopper lid or owners manual. Close the door and set the
thermostat to a desired temperature. Unit is now ready to resume normal operation.
10