Heatilator ECOCHOISE CAB50-C - 1 Listing and Code Approvals; Appliance Certification; BTU & Efficiency Specifications

7August 23, 2019 7074-801C
HEATILATOR ECO CHOICE CAB50
Model CAB50-C
Laboratory Intertek
Safety
Report No.
4001508
Type
Solid Fuel Room Heater/Pellet Fuel
Burning Type
Standard
ASTM E1509-04 and ULC S627-00,
ULC/ORD-C1482-M1990 Room Heater
Pellet Fuel Burning type and (UM) 84-
HUD, Mobile Home Approved.
B. BTU & E󰀩ciency Specications
1 Listing and Code Approvals
A. Appliance Certication
NOTICE: This installation must conform with local codes. In the absence of local codes you must comply with the
ASTM E1509-04, ULC S627-00, (UM) 84-HUD and ULC/ORD-C-1482.
This pellet heater needs periodic inspection and repair for proper operation. It is against federal regulations to operate this
pellet heater in a manner inconsistent with operating instructions in this manual.
Laboratory: OMNI Test Laboratories, Inc.
Emissions Report #: 0061PS085E
EPA Certied
Emissions:
1.0 grams/hour
*LHV Tested E󰀩ciency: 69.5%
**HHV Tested E󰀩ciency: 65.1%
***EPA BTU Output: 7,500 to 36,600 per hr.
****BTU Input: 13,100 to 49,900 per hr.
Vent Size: 3 or 4 inches, “L” or “PL”
Hopper Capacity: 120 lbs.
Fuel Premium Wood Pellets
*Weighted average LHV (Low Heating Value) e󰀩ciency
using data collected during EPA emissions tests..
**Weighted average HHV (High Heating Value) e󰀩ciency
using data collected during EPA emissions tests.
***A range of BTU outputs calculated using HHV
e󰀩ciency and the burn rates from the EPA tests.
****Based on the maximum feed rate per hour multiplied
by approximately 8600 BTU’s which is the average BTU’s
from a pound of pellets.
‡ Grade of pellet fuel as certied by Pellet Fuels Institute (PFI), ENPlus
or CANplus.
The CAB50 is Certied to
comply with 2020 particulate
emission standards.