21 / 32
EN
STARTING
Start the engine at a minimum distance of 3 meters from the place of supply of fuel.
1. To start the engine press the power button on the control handle with the symbol (I) (fig. 6A).
2. For cold start, set the choke lever to „START“. For warm start let choke lever in position „RUN“ (fig. 7A).
3. Press the primer 10x (fig. 7B).
4. Set throttle lever to half throttle (fig. 6B) and press the lock button (fig. 6C).
5. Hold the device by one hand for tube handle. By other hand pull the starter cord (fig. 7C)
several times (first pull cord slowly, until you don´t feel resistance, then pull rapidly) until
engine starts.Attention! Do not pull the starter cord too far - risk of cord breakage! Return
Cord careful risk of damage of the starter.
6. If the device does not starts at 4-6 pull, repeat step 1 to 5.
7. If the engine takes up, but is not running, set the choke lever to "RUN" and continue cranking.
8. When the engine starts and runs, press the throttle lever to release it from the mid throttle.
Set the choke lever to position "RUN".
9. Let the engine warm up for about 20 seconds.
WARNING! Keep hands and feet away from the rotating parts.
Start the engine carefully according to instructions and with body parts, especially feet well away
from the auger bit. Do not tilt the lawn mower when starting the engine.
During operation, firmly hold the machine with both hands.
Press the handles lightly downward to drill a hole.
Raise the auger frequently to help clear drilling debris from the hole.
Overloading the auger during drilling may cause it to stop turning. When this occurs, lift the
auger to reduce the drilling load on the motor, and allow drilling debris to be augered out of the
hole and resume drilling.
Do not place excessive body weight on the machine.
Do not use an ice auger bit in earth or an earth auger bit in ice. A different style of
auger bit is required for each type of drilling.
TO STOP ENGINE
CAUTION: The auger continues to rotate for a few seconds after the engine is shut off.
For stop the engine switch the power button on multifunkcional handle into position ( 0 ) (fig. 6A).
MAINTENANCE
Good maintenance is essential for safe, economical and trouble-free operation.
WARNING! Improper maintenance, or failure to correct a problem before operation
or use of non-conforming replacement components, can cause malfunction in
which you can be seriously hurt or killed.
Disconnect the spark plug before performing any service on the machine. Wait till
all moving parts are completely stopped.
• Always follow the inspection and maintenance recommendations and schedules in this manual.
• To help you properly care for your engine, the following pages include a maintenance schedule,
routine inspection procedures, and simple maintenance procedures using basic hand tools.
To Next Page
Loading...