25 / 32
EN
TRANSPORTATING
Warning!!! Let the engine to cool down before transporting the machine.
The fuel tank must be empty. Spilled fuel or fuel vapor may ignite.
1. Empty the fuel tank before transporting the machine.
2. Empty the petrol tank with a suction pump. Start the engine and let it run until it has used
up all remaining petrol and stalls.
3. Close the fuel cap firmly.
4. Turn the engine switch and fuel valve (if equipped) to the off or stop position.
5. Let the engine to cool down before transporting.
6. Take care not to drop or strike the machine when transporting.
7. Tie down the machine securely in an upright position while transporting.
8. Take care not to strike the machine when transporting. Do not place objects on the machine.
TIP: It is possible to disassemble the drill (tool) from the drive unit during transport and storage
for a better compactness.
TROUBLESHOOTING
J
CAUTION Failures of your machine which require larger interference must always be eliminated
by specialized workshop. Unauthorized interferences can cause damages. If you can not rectify
the fault using the measures described here, contact an authorized service center.
Problem Possible cause Problem solution
Engine does not start
Fuel tank is empty Refuelling
Incorrect sequence of steps while
start
Keep starting instructions
Engine is „flooded“
Close the throttle, start several
times, if necessary remove spark
plug, clean and dry it
Spark plug contaminated by car-
bon. Incorrect spark gap
Clean, adjust or replace spark
plug
Damaged spark plug cable or
connectors
Replacement
Dirty carburetor, jets, incorrectly
adjusted carbureting mix
Let adjust the carburetor in
authorised service center
Clogged fuel filter Cleaning or replacement
Engine runs in idle too
quickly
Cold engine Slowly let warm.
To Next Page
Loading...