hecht 52 - Storage and Transport

24 / 32
EN
SK
PL
HU
CS
Machine part Action Before each use
Operating
hours
20
Screws, nuts,
bolts
Check, fasten
 
Air filter Clean or replace  (*)
Fuel filter Replace

Spark plug Clean/adjust/replace

Fuel hose Check, replace if necessary

Complete machi-
ne
Check, clean if necessary after each use
Control handle Check function

Drill Check correct assembly

* In a dusty environment more often
In the case that the tool moves at idle speed, locate an authorized service center
immediately.
STORAGE AND TRANSPORT
CAUTION! The engine must have completely cooled down before storing the
machine.
NOTE: For future reference, you should keep this operator‘s manual. Do not store
your unit for a prolonged period of time (30 days of longer) without performing
protective storage maintenance which includes the following:
• Place the ignition switch in the „STOP“ position.
• Allow the engine to cool before storing in any enclosure.
• Replace worn or damaged parts for safety.
• Store the machine in a dry, clean and frost-protected place, out of reach of unauthorized persons.
• Machine and parts of accessories clean after each use. This prevents the formation of mold.
• Do not store the device a long time in direct sunlight.
• Cover unit with a suitable protective cover that does not retain moisture. Do not use sheet
plastic as a dust cover. A nonporous cover will trap moisture around the mower, promoting rust
and corrosion metal parts.
• Store unit in a dry, dust free place, out of the reach of children and other unauthorized persons.
1. Drain off the fuel tank on well ventilated place.
2. Start the engine and let it run idle till stops itself due to shortage of fuel in carburetor.
3. Let engine get cold (ca 5 minutes).
At operation breaks longer that 3 months:
1. Loosen spark plug by respective tool (see chapter Replacement/Adjustment of spark plug)
2. Combusting chamber fill by 2 spoonfuls of clean oil for 2-stroke engines and several time
pull slowly the startin rope in order to stir evenly the oil in the engine.
3. Screw back the spark plug