17 / 28
• If there is a cut, cover the wound with a clean bandage (fabric) and press down firmly to
stop the bleeding.
• If the skin is burnt, avoid further exposure to the source of burns first. Cool the injured areas
of smaller extend with water of preferably about 4-8 °C. Do not put ointments, creams or
dusting powders on the affected area. The best way is to use a wet compress, for example
a handkerchief or a towel. Then secure the sterile cover and, if necessary, seek medical attention.
• If persons with circulatory problems are often exposed to excessive vibration, they may
experience injury to blood vessels or their nervous system. The vibrations may cause
the following symptoms appear on fingers, hands or wrists: numbness, itching, pain, tingling,
changes in skin colour or of the skin itself. If any of these symptoms occur, consult a doctor.
• When an electric shock is caused, it is necessary more than anywhere else to put emphasis
on safety and risk elimination for the rescuers. The affected person usually stays in contact
with electrical equipment (source of injury) because of muscle spasms caused by the electric
shock. Traumatic process continues in this case. It is therefore necessary to TURN THE
POWER OFF FIRST using any possible way. Subsequently CALL AN AMBULANCE or other
professional service, and then PROVIDE FIRST AID! Ensure free airways, check breathing,
check pulse, put the affected flat on their back, bend their head and stick out their lower
jaw. If necessary, begin with artificial respiration into the lungs and heart massage.
IN CASE OF FIRE:
• To extinguish the fire, use suitable fire extinguisher (snow, powder, halotron).
• DO NOT PANIC. Panic can cause even more damage.
RESIDUAL RISKS
• Even if the device is used according to instructions, it´s impossible to eliminate all the risks
associated with its operation. The following risks may occur arising from device construction:
• Electrical hazard caused by touch with live parts (direct contact) or with parts, which came
under a voltage due to failure of the device (indirect contact).
• Heat hazard resulting in burning or scalding and other injuries caused by possible contact
with high temperature objects or materials including heat sources.
• Dangers caused by failing in ergonomic principles by construction of the machine, for example
dangers caused by unhealthy position of body or excessive overcharge and unnature to the anatomy
of the human hand-arm, relate to construction of handle, equilibrium of the machine.
• Dangers caused by unexpected starting, unexpected exceeding of motor revs caused by
defect/failure of control system, relate to the defects by the handle and placing of drivers.
• Dangers caused by impossibility to stop the machine in best conditions, relate to solidity of
the handle and placing of motor shut down device.
• Dangers caused by defect of machine control system, relate to solidity of the handle, placing
of drivers and marking.
• Dangers caused by shooting up of subjects or splashing of liquids.
• Mechanical hazard, caused by cut and throw off.
• Noise risk resulting in loss of hearing (deafness) and other physiological disorders (e.g. loss
of balance, loss of consciousness).
• Vibration risk (resulting in vascular and neurological harm in the hand-arm system, for
example so called “white finger disease”).
HECHT_675_manual_2019_ EN.indd 17 11.03.2019 8:03:24
To Next Page
Loading...
