19 / 28
ASSEMBLY AND ADJUSTMENT OF THE AUXILIARY HANDLE (FIG. 3)
Place the auxiliary handle to telescopic tube which near to rear handle
r
, adjustment the auxiliary
handle to a comfortable working position and tighten the screw (Fig. 2) by Allen key (Fig. 3) firmly.
ASSEMBLY AND USE OF THE SHOULDER STRAP (FIG. 4)
Assembly:
Use your thumb or fingers to squeezing the safety lock piece (Fig. 2), put the hook to the hanging
part (Fig. 3) of the tool.
Move slide buckle (Fig. 4) to adjust the length of the shoulder strap. Adjust the length of
the shoulder strap to obtain a comfortable working position.
Put the shoulder strap over your right shoulder. Carry the tool engine at the right side of your body.
Disassembly:
Remove the safety lock piece in the opposite way.
Take off the shoulder strap.
ASSEMBLY OF THE PORTABLE HEDGE TRIMMER (FIG. 5)
Open the quick release button
e
of the housing.
Put the rear handle
r
into the opening of the housing.
Lock the quick release.
SWITCHING ON AND OFF
STARTING AND STOPPING TELESCOPIC HEDGE TRIMMER (FIG. 6)
To start the tool: press the safety button
k
and then press the trigger
l
. Release the safety
button once the motor has started.
To stop the trimmer: Release the trigger.
STARTING AND STOPPING PORTABLE HEDGE TRIMMER (FIG. 7)
To start: Grasp the front handle with one hand, and press the front handle switch
q
. Then grasp
the rear handle with the other hand, and press the safety lock
k
first, then operate the rear
handle switch
l
. Release the safety button once the motor has started.
To stop: Release one of the two switches
q
,
l
.
The blade brake causes the blades to stop within 1.0 seconds.
WORKING WITH THE TRIMMER
• During cutting work, ensure that no contact is made with objects, e.g. such as wire fencing
or main plant stems. This may result in damage to the cutter bar.
• Always hold the equipment firmly in both hands, with one hand on the rear handle and
the other on the front handle. Thumbs and fingers must be firmly around the handles.
• Switch off the equipment immediately in the event that the blades are blocked by solid
objects, pull out the power plug then remove the object.
• Always work away from the mains power outlet. Set the cutting direction before starting
work. Ensure that the power cable is kept well away from the working area. Never lay
the cable over the hedge, where it could easily be caught up in the trimmer blades.
• Avoid overstraining the equipment during work. Pull out the power plug immediately if
the cable is damaged, badly twisted or has been completely cut through.
• Never work without fixed position, for example on ladder.
• After use, place the blade sheath supplied over the blades.
HECHT_675_manual_2019_ EN.indd 19 11.03.2019 8:03:24
To Next Page
Loading...
