22 / 28
for all moving parts to stop and allow the machine to cool down. Prevent the engine
from being started accidentally (disconnect the power unit from the mains).
THIS WARNING IS NOT REPEATED IN ANY FOLLOWING POINTS!
• Always make sure that all nuts and bolts are firmly tightened and make sure the machine is
in good working order.
• Keep the machine in good condition, if necessary change warning and instruction labels on
the machine.
• Always ensure that the ventilation openings are kept clear of debris.
• For safety reasons, replace worn or damaged parts. Only use original spare parts and
accessories. Parts not tested and approved by the equipment manufacturer can cause
unforeseeable damage.
• Repair and maintenance work other than described in this section, which are more
complicated, or it needs special tools, let it on our authorized service.
CLEANING
CAUTION!A
Never spray the product with water or expose it to water. In any case, do not wash
by water the parts of machine, which are not intended for it.
Never use aggressive detergents or solvents for cleaning.
1. Carefully clean the machine after each use.
2. Do not let the handles contaminate with oil or grease. Clean the handle clean with a damp
cloth washed in soapy water. Never use aggressive detergents or solvents for cleaning. This can
cause irreparable damage to the product. The plastic parts can be eaten away by chemicals.
3. Wipe down the product with a slightly damp cloth or with brush.
4. Clean the cover of the machine, especially the ventilation holes.
5. If any of the parts of the machine is cleaned by water or a damp cloth, etc., it must be
completely dry. Then the metal parts must be grease against the corrosion with suitable
protective oil. Make sure that the water doesn´t leak into the internal parts of the machine.
6. Potential damage of the parts due to corrosion, can not be assessed as a manufacturing or
material defect.
7. Clean the cutter bar carefully after each use. Apply the lubricating and preservative oil.
STORAGE
• Store the machine out of reach of children.
• Turn the motor off and disconnect the mains plug if the machine is not used.
• Allow let the machine to cool down before storage.
• Do not store the machine a long time in direct sunlight.
• Replace worn or damaged parts for safety.
• Store machine in a clean, dry, dark and frost-free place, protected from dust and out of
reach of children. The ideal storage temperature is between 5 and 30°C.
• Use the original packaging to storage whenever possible.
• Cover unit with a suitable protective cover that does not retain moisture. Do not use sheet
plastic as a dust cover. A nonporous cover will trap moisture around the machine, promoting
rust and corrosion.
HECHT_675_manual_2019_ EN.indd 22 11.03.2019 8:03:24
To Next Page
Loading...
