23 / 28
TRANSPORT
Turn the motor off and disconnect the mains plug. When transporting, be careful not to drop,
or otherwise shock the machine. For transport, the machine has to be fixed against slipping and
tipping over. Do not place objects on the machine.
• When transporting or storing the machine always fit the cutting device guard.
• When hand-carrying the product, cover over the cutting part if necessary, lift up the product
and carry it paying attention to the blade.
TROUBLESHOOTING
CAUTION!A
Failures of your machine which require larger interference must always be eliminated
by specialized workshop. Unauthorized interferences can cause damages. If you can
not rectify the fault using the measures described here, contact an authorized service.
Problem Possible cause Fault correction
Device does not
start
Mains voltage not on
Check plug socket, the electric
supply, where appropriate, have
repaired through electrical specialist
On/Off switch defective
Repair by authorized service centreWorn carbon brushes
Defective motor
Device runs with
interruptions
Power cable is damaged
Check the extension cable and leave
it changed if necessary
Internal loose electrical connection
Repair by authorized service centre
On/Off switch defective
Low quality of
the cut
Cutting bar is blunt
It is necessary to sharpen or leave
change the cutting bar
Motor runs but
the cutting bar
does not move
The bar is blocked by the thick
branch or an other objects
Shears off as soon as possible, unplug
them from the socket and remove
the object blocking the bar.
WARNING!B
Faults which can not be rectified with the aid of this table may be rectified by
a authorized service centre.
SERVICE AND SPARE PARTS
• Have your device serviced by a qualified repair personnel using only identical replacement
parts. This will ensure that the safety of the device is maintained.
HECHT_675_manual_2019_ EN.indd 23 11.03.2019 8:03:24
To Next Page
Loading...
