17 / 31
PREPARATION
• Examine the machine ensure it is in good condition, check all the screws, nuts and other
fasteners are properly secured and the screen is in place. Replace unreadable labels.
• Keep all guards and deflectors in place and in good working condition.
• Check the machine before an each use to determine whether the working tools are not
worn or damaged. Replace worn or damaged parts.
WORK AREA
• Do not operate in explosive atmospheres, such as in the presence of flammable liquids,
gases, or dust. Product create sparks which may ignite the dust or fume.
• Check the terrain where you are going to use the machine, and remove any objects that
could be caught, tangled, or discarded (stones, shards of glass, nails, wires, toys, sticks, etc.).
Only operate the machine on a safe surface and only in good light!
• Never use the machine during rain and storms, especially if there is a risk of lightning strikes.
• Never use the machine on a slippery surface.
• Keep children and bystanders away while operating the machine. Distractions can cause
you to lose control.
• While working, make sure that you stand firmly. Be particularly careful when working on
sloping terrain.
ELECTRICAL SAFETY
WARNING! B
Do not connect a damaged cable or touch the damaged cable before disconnecting
from the network. This can cause an electric shock. In case of damage to the supply,
have it replaced by an authorized service centre. This prevents a dangerous situation.
Keep track of where you have an extension cable. Damage of the extension cord
or cables may result in serious electrical shock, and in a better case only material
damage may occur.
Note: I
It is good to have the extension cable in a distinctive colour in order to not to overlook,
cross, cut through or trip over it.
• Protect yourself against electric shock.
• Do not expose to rain or use in damp or wet conditions.
• Regularly check the supply cable and check for signs of damage or aging.
• Avoid accidental starting.
• Use only extension cables with sufficient section, which are approved for this purpose and
labelled accordingly.
• Cable drum before using completely unwind.
• Prevent spontaneous fall of small objects into the product.
• Never use brute force.
ELECTRICAL REQUIREMENTS
• Never use at the nominal voltage other than 230V/50Hz. The circuit must be properly and
accordingly current protected.
Manual_HECHT_715_745_7445_2024_EN.indd 17Manual_HECHT_715_745_7445_2024_EN.indd 17 08.07.2024 14:51:2808.07.2024 14:51:28
To Next Page
Loading...
