23 / 31
Better growth will be obtained if an area is tilled properly and used soon after tilling to preserve.
the moisture content. The type of soil and working conditions will determine the actual setting of
the tilling depth. In some soils, the desired depth is reached first pass over garden. In other soils,
the desired depth is obtained by going over the garden two or three times. In later case, the depth
regulator rod should be lowered before each succeeding pass over the garden. Passes should be
made across the length and width of the garden alternately. Do not try to dig too deeply in the irst
pass. If the machine jumps or bucks, allow the unit to move forward at a lightly faster rate. If
the tiller stops forward motion and tries to dig in one spot, rock the handles from side to side to
start it moving forward again. Rocks which are turned up should be removed from the garden area.
MAINTENANCE AND STORAGE
CAUTION! A
To ensure proper functioning of the machine, it is necessary to have it checked and
adjusted by qualified personnel in an authorized service centre at least once a year.
Proper maintenance is essential for safe, economic and trouble-free operation of
the machine.
Failure to follow the maintenance instructions and safety precautions may cause serious injury
or death. Always follow the procedures, safety precautions, recommended maintenance and
recommended checks mentioned in this manual.
WARNING! B
Prior to any work on the machine (maintenance, inspection, replacement of
accessories, servicing) or before storing it, ALWAYS SWITCH THE ENGINE OFF, wait
for all moving parts to stop and allow the machine to cool down. Secure the machine
(apparatus) against accidental start-up by disconnecting it from the power supply.
THIS WARNING IS NOT REPEATED IN ANY FOLLOWING POINTS!
• Always make sure that all nuts and bolts are firmly tightened and make sure the machine is
in good working order.
• Keep the machine in good condition, if necessary change warning and instruction labels on
the machine.
• Always ensure that the ventilation openings are kept clear of debris.
• For safety reasons, replace worn or damaged parts. Only use original spare parts and
accessories. Parts not tested and approved by the equipment manufacturer can cause
unforeseeable damage.
CHANGING THE TINES
The tool is fitted with four tine wheels that can easily be changed in pairs. Both of the tine whell
pairs can be fitted on the left or right, as required.
Always change both tine pairs at the same time to avoid damage to the tool from imbalance.
1. Switch the tool off, unplug it and wait for the tines to stop turning.
2. Put the machine on the straight surface, the type lable has to be placed upside.
Manual_HECHT_715_745_7445_2024_EN.indd 23Manual_HECHT_715_745_7445_2024_EN.indd 23 08.07.2024 14:51:2808.07.2024 14:51:28
To Next Page
Loading...
