25 / 31
STORAGE
• Store the machine out of reach of children.
• Turn the motor off and disconnect the mains plug if the machine is not used.
• Allow let the machine to cool down before storage.
• Do not store the machine a long time in direct sunlight.
• Replace worn or damaged parts for safety.
• Store machine in a clean, dry, dark and frost-free place, protected from dust and out of
reach of children. The ideal storage temperature is between 5 and 30°C.
• Use the original packaging to storage whenever possible.
• Cover unit with a suitable protective cover that does not retain moisture. Do not use sheet
plastic as a dust cover. A nonporous cover will trap moisture around the machine, promoting
rust and corrosion.
TRANSPORT
Turn the motor off and disconnect the mains plug. When transporting, be careful not to drop,
or otherwise shock the machine. For transport, the machine has to be fixed against slipping and
tipping over. Do not place objects on the machine.
TROUBLESHOOTING
CAUTION! A
You cannot rectify disorders that require more intervention yourself.
If you‘re unable to rectify the fault using the corrective measures described below,
contact a specialist garage, preferably an authorised service centre.
Improper handling can cause damage or serious injuries.
PROBLEM PROBABLE CAUSE CORRECTIVE ACTION
Motor does not
start
No electricity goes to the
machine.
Check the power supply and
the power line.
Faulty motor connections or
switch defect
Have it checked by an electrician
Motor turns off
automatically
Thermoprotection is triggered
Motor can be turned on again after the cooling
period.
Abnormal noises
Blade is jammed
Switch off and wait till complete stop.
Remove the objects.
Lubrication running out Contact authorized service center.
Screws or parts of the machine
are loose.
Tighten all screws.
Excessive vibration
Blades damaged or worn
Replace or have it checked by an
authorized service center
Working depth too large Set to correct working depth
Manual_HECHT_715_745_7445_2024_EN.indd 25Manual_HECHT_715_745_7445_2024_EN.indd 25 08.07.2024 14:51:2808.07.2024 14:51:28
To Next Page
Loading...
