Hectronic Citea - 3.2.10. Safe Locks; Installation of External Solar Module

Installation & Commissioning
40
Hectronic GmbH | Allmendstrasse 15 | D-79848 Bonndorf | Tel. +49 7703 9388-0 | Fax +49 7703 9388-60 | mail@hectronic.com
Managing Directors: Stefan Forster, Eckhard Fechtig, Frank Gampp | District Court Freiburg, HRB 621170 | VAT ID No.: DE170986709
3.2.9. Installation of External Solar Module
3.2.10. Safe Locks
The safe is equipped with a changeable lock. The locks of new parking machines must always be programmed.
Carry out the programming as follows:
1. Open the safe with the factory key (marked "WS") and remove the key from the lock again.
2. Insert the "activator" key (marked "A") into the lock of the open safe door and turn it to the left until it stops.
3. Remove the "activator" key from the lock.
4. Insert the factory key into the lock again and turn it 180°.
5. Remove the factory key from the lock.
6. Insert the customised key into the lock and lock the safe.
The lock is now programmed to the customer-specific key.
Pipe post
76 mm