Heiniger ICON - Malfunction List

12 Instruction manual ICON
Firstly,findoutwhereexactly
onthehandpiecetheheatis
comingfrom.Letitcooldown.
Startagainandattemptto
locatetheoriginalheatsource.
Handpiecerunshot.
Istheresandand/orgritinside
thefrontofthebarrel.
Withcombandcutterin
placeandafirmgriponyour
handpiece,putyourthumbover
theoilholeandfillthebarrel
withoilfromthefrontwhilethe
handpieceisrunning.Whilst
stillrunningturnitupsidedown
anddraintheoilout.
Checkthatyourcomband
cutteraresharpandnotover
tensioned.
Resharpen.Thenuseless
tension.
Centreposthasdirtbetweenit
andthecentrepostcup.
Heatonthumborforefinger. Removethecutter,turnthe
handpieceupsidedownandoil
thecentrepostcupliberally.
Topoftensionpinandinside
tensionsleeve.
Hot tension nut. Firstcleanoutthetension
sleeveandcleanthetension
pin.Regreaseandtryagain.
Haveyouputtheballonthe
wrongwayaround?Theflat
sidegoestothecrankhead.
Hotonringfingerormiddleof
handpiece.
Removeandturnaround.
Woolbuildupbetweenball
andcrankheadaroundthe
crankpin.
Removewool.
Topofthetensionpinisworm. Replacetensionpinandsleeve.
Centrepost&cuparewell
worm.
Fitshortrepairkit.
Heatfromfrontregionin
general.
MALFUNCTION RECTIFICATIONCAUSE
5.4 Malfunction List
Actions to be taken to rectify malfunctions are indicated in the „Rectification“ column of the malfunction
list. Those rectification notes printed on a dark background may only be carried out by a trained person or
an authorised service centre.
Uselesstensionorresharpen
comb and cutter.
Frontbearingsisrunninghot,
probablycausedbytoomuch
tension or blunt comb and
cutter.
Replacebearings.Hasthecrankgotalotof
movementupanddowninside
thebearing?