Heinner HDW-FS4552WE++ - Page 9

www.heinner.com
8
To remove the top panel, remove the screws that hold it on, located at the rear of the machine.
Then, push the panel 1 cm from the front towards the rear and lift it. Adjust the machine feet
according to the slope of the floor (3).
Fit your machine by pushing it under the counter taking care not to crush or bend the hoses
(4).
WARNING: After removing the top panel of your dishwasher, the machine should be placed in
a space of the dimensions shown in the figure below.
A
B
All Products
B
1
B
2
Product’s Height (±2 mm)
820 mm
825 mm
835 mm
A: If there is no felt on the top of the product; you should take into account this product’s
height.
B1: If there is felt on the top of the product with 2nd basket; you should take into account this
product’s height.
B2: If there is felt on the top of the product with 3rd basket; you should take into account
this product’s height.