40
Fig.7-6 Key Switch
Turn the key switch clockwise to the second “on”position (starting position),
then start the engine.
Release the brake switch before starting, Otherwise, the forklift truck can not
step because the drive unit is cut off.
After engine starting，push the shiftlever forward (that is in forward shifts), then
pedal accelerator shift, the forklift truck runs faster and you can begin to work. When
pull the shiftlever backward(that is in reverse shifts), the backing lamp is on and the
buzzer sounds. Forward and backward are each four shifts. The numeral is more
bigger, the speed is more higher.
7.3.2 Lamp Switch
(1) Turn the lamp switch clockwise to the first “on”position, the front lamps and
rear lamps are on, turn the lamp switch to the second “on”position, the headlight on
near beam are on while the front lamps and rear lamps keep on, turn the lamp switch
to the third“on”position, the headlights on full beam are on while the front lamps and
rear lamps keep on, but the headlight on near beam is off.
(2) Push the turning switch forward, the left turning lamps on the front combination
lamp and the rear combination lamp flash. Pull the turning switch backward, the right
turning lamps on the front combination lamp and the rear combination lamp flash.
(3) Brake Signal: When you pedal brake, the brake lamps (red)in the rear
combination lamp are on. While the truck brake, the transmission of power is cut
To Next Page
Loading...
