JS07N·JS07·JS08·JS12·JS14
8
Work Area Safety
Be aware of crushing hazards when grasping
the platform guard rail.
Observe and use color-coded direction arrows
on the platform controls and the platform decal
plate for drive and steer functions.
Do not operate a machine in the path of any
crane or moving overhead machinery unless
the controls of the crane have been locked out
and/or precautions have been taken to prevent
any potential collision.
No stunt driving or horseplay while operating a
machine.
Do not lower the platform unless the area be-
low is clear of personnel and obstructions.
Limit travel speed according to the condition
of the ground surface, congestion, slope, lo-
cation of personnel, and any other factors
which may cause collision.
Component Damage Haz-
ards
Do not use any battery charger greater than
24V to charge the batteries.
Do not use the machine as a ground for weld-
ing.
Explosion and Fire Hazards
Only in the open, ventilated and away from fire
place such as sparks, flame and burned ciga-
rettes, can charge for battery.
Do not operate the machine in hazardous loca-
tions or locations where potentially flammable
or explosive gases or particles may be present.
Damaged Machine Hazards
Do not use a damaged or malfunctioning ma-
chine. Conduct a thorough pre-operation in-
spection of the machine and test all functions
before each work shift. Immediately tag and re-
move from service a damaged or malfunction-
ing machine.
Be sure all maintenance has been performed
as specified in this manual and the appropriate
service manual.
Be sure all decals are in place and legible.
Be sure the operator's, safety and responsibil-
ities manuals are complete, legible and in the
storage container located on the machine.
Bodily Injury Hazard
Do not operate the machine with a hydraulic oil
or air leak. An air leak or hydraulic leak can
penetrate and/or burn skin.
Improper contact with components under any
cover will cause serious injury. Only trained
maintenance personnel should access com-
partments. Access by the operator is only ad-
vised when performing a pre-operation inspec-
tion. All compartments must remain closed and
secured during operation.
Battery Safety
Burn Hazards
Batteries contain acid. Always wear protective
clothing and eye wear when working with bat-
teries.
Avoid spilling or contacting battery acid. Neu-
tralize battery acid spills with baking soda and
water.
Do not expose the batteries or the charger to
water or rain during charging.
To Next Page
Loading...