JS07N·JS07·JS08·JS12·JS14
9
Work Area Safety
Explosion Hazard
Keep sparks, flames and
lighted tobacco
away from batter-
ies. Batteries emit
explosive gas.
The battery tray should
remain open during the
entire charging cycle.
Do not contact the bat-
tery terminals or the ca-
ble clamps with tools that
may cause sparks.
Component Damage Hazard
Do not use any battery charger greater than
24V to charge the batteries.
When the battery power is insufficient or ex-
cessive discharge, do not operate the machine.
Electrocution/Burn Hazards
Connect the battery charger to a grounded, AC
3-wire electrical outlet only.
Inspect daily for damaged cords, cables and
wires. Replace damaged items before operat-
ing.
Avoid electrical shock from contact with battery
terminals. Remove all rings, watches and other
jewelry.
Tip-over Hazards
Batteries are used as counterweight and are
critical to machine stability. Do not use batter-
ies that weigh less than the original equipment.
Each battery must weigh 28kg(JS1212 battery
is 36kg), Battery tray including batteries must
weigh a minimum of the following requirements:
Model Weight of tray
JS0407NE,JS0407NELi 78 kg
JS0607,JS0607Li,
JS0607E,JS0607ELi,
JS0607W,JS0607WLi,
JS0607WE,JS0607WELi
154 kg
JS0808, JS0808Li,
JS0808E, JS0808ELi
JS0612, JS0612Li,
JS0612E, JS0612ELi,
JS0812, JS0812Li,
JS0812E, JS0812ELi
JS1012, JS1012Li,
JS1012E, JS1012ELi
180 kg
JS1212, JS1212Li,
JS1212E, JS1212ELi
212 kg
JS1414, JS1414Li,
JS1414E, JS1414ELi
212 kg
Lift Hazard
Use the appropriate number of people and
proper lifting techniques when lifting batteries.
Lockout after each use
1. Select a safe parking location—firm level
surface, clear of obstruction and traffic.
2. Lower the platform.
3. Turn the key switch to the off position and
remove the key to secure from unauthor-
ized use.
4. Chock the wheels.
5. Charge the batteries.
To Next Page
Loading...