JS07N·JS07·JS08·JS12·JS14
16
Controls
Code
Problem
Action
Limit
Solution
21
FAULT BMS
TEMPERA-
TUR1 BMS1
Diagnostic
Message
Only
Lithium battery discharge temperature is too high error:
check whether the lithium battery temperature is too
high and leave it for a period of time. If it still fails, con-
tact the manufacturer.
22
FAULT BMS
CURRENT1
BMS1
Diagnostic
Message
Only
Lithium battery discharge current too high error: check
whether the whole vehicle operates normally. If it still
fails, contact the manufacturer.
23
FAULT BMS
TOTAL VOL
LOW1 BMS1
Diagnostic
Message
Only
Error of low total voltage of lithium battery: check the
voltage at both ends of lithium battery and try to charge
if the battery is low. If it still fails, contact the manufac-
turer.
24
FAULT BMS
MONMETER
VOL LOW1
BMS1
Diagnostic
Message
Only
Lithium battery cell voltage too low error: check whether
the lithium battery is low and try to charge it. If it still
fails, contact the manufacturer.
25
FAULT BMS
MONOMER
VOL LOW
BMS
Disables
All Motion
Lithium battery cell voltage too low error: check whether
the lithium battery is low and try to charge it. If it still
fails, contact the manufacturer.
26
FAULT VOL
DIFFERENT
LARGE
Disables
All Motion
Lithium battery cell voltage too low error: check whether
the lithium battery is low and try to charge it. If it still
fails, contact the manufacturer.
27
FAULT TEM
DIFFERENT
LARGE
Disables
All Motion
Error of too large temperature difference of lithium bat-
tery: check whether the temperature of lithium battery is
too high, and let it stand for a period of time. If it still
fails, contact the manufacturer.
28
FAULT BMS
CURRENT
HIGH
Disables
All Motion
Lithium battery discharge current too high error: check
whether the whole vehicle operates normally and leave
it standing for a period of time. If it still fails, contact the
manufacturer.
29
FAULT BMS
TEMPERA-
TURE
Disables
All Motion
Lithium battery discharge temperature too high error:
check whether the lithium battery temperature is too
high. If there is no problem, contact the manufacturer.
31
Pressure
Sensor Fault
Disables
All Motion
Pressure Sensor Fault: Check the wiring to the sensor
and then the sensor itself. Also check to make sure that
the correct option is properly selected (or not) for load
sensing
32
Angle Sensor
Fault
Disables
All Motion
Angle Sensor Fault: Check the wiring to the sensor and
then the sensor
itself. Also check to make sure that the correct option is
properly selected (or not) for load sensing
33
Anti collision
switch Fault
Disable
Lifting and
Driving
Anti collision switch fault error: check whether the anti-
collision switch is placed correctly and confirm that there
is no problem. If there is no problem, check whether the
anti-collision switch wiring is correct.
35
Pressure
Sensor2 Fault
Disables
All Motion
Pressure sensor error: check the sensor wiring and the
sensor itself. You can also check that the correct ma-
chine option with overload detection is selected.
36
Battery Drain
Alarm
Lift Slow to
Drive
Speed
Limp Mode: Battery voltage is low, charge the battery.
37
Battery Drain
Shutdown
Disables
All Motion
Battery Drain Shutdown：Recharge.
To Next Page
Loading...