HELI JS07N - Page 42

JS07N·JS07·JS08·JS12·JS14
40
Maintenance
Checklist A.
Y
N
R
A-1 Inspect the manuals and decals
A-2 Pre-operation inspection
A-3 Function tests
After 40 hours:
A-4 30-day service
After 100hours:
A-5 Grease steer yokes
Checklist B
Y
N
R
B-1 Batteries
B-2 Electrical wiring
B-3 Electrical contactor
B-4 Tires and wheels
B-5 Emergency stop
B-6 Key switch
B-7 Horn
B-8 Drive brakes
B-9 Drive speed - stowed
B-10 Drive speed - raised
B-11 Drive speed - slow
B-12 Hydraulic oil analysis
B-13 Tank venting system
B-14 Chassis tray component
B-15 Test down limit and pothole limit
B-16 Test up limit switch
Checklist C
Y
N
R
C-1 Platform overload system
C-2 Replace hydraulic tank breather cap
Checklist D
Y
N
R
D-1 Check the scissor wear-resisting
D-2 Replace the Hydraulic Tank Return
Checklist E
Y
N
R
E-1 Hydraulic oil
Checklist A
A-1
Inspect the Manuals and Decals
Maintaining the operator’s and safety manuals
in good condition is essential to safe machine
operation. Manuals are included with each ma-
chine and should be stored in the container
provided in the platform. An illegible or missing
manual will not provide safety and operational
information necessary for a safe operating
condition.
In addition, maintaining all of the safety and in-
structional decals in good condition is manda-
tory for safe machine operation. Decals alert
operators and personnel to the many possible
hazards associated with using this machine.
They also provide users with operation and
maintenance information. An illegible decal will
fail to alert personnel of a procedure or hazard
and could result in unsafe operating conditions.
1. Check to make sure that the operator's
and safety manuals are present and
complete in the storage container on the
platform.
2. Examine the pages of each manual to be
sure that they are legible and in good
condition.
Result: The operator's manual is appropri-⊙
ate for the machine and all manuals are legi-
ble and in good condition.
¤ Result: The operator's manual is not ap-
propriate for the machine or all manuals are
not in good condition or is illegible. Remove
the machine from service until the manual is
replaced.
3. Open the operator's manual to the decals
inspection section. Carefully and thor-
oughly inspect all decals on the machine
for legibility and damage.
Result: The machine is equipped with all⊙ re-
quired decals, and all decals are legible and
in good condition.
¤Result: The machine is not equipped with
all required decals, or one or more decals are
illegible or in poor condition. Remove the ma-
chine from service until the decals are re-
placed.