34
English
CAUTION
• Improper reconditioning of the airbag vest could prevent it from working properly.
You must carefully follow the order of the steps below.
• The airbag vest must be reconditioned in a clean environment (away from dust,
not on the oor, etc).
• After an ination, the cartridge is pierced and therefore empty. You must not
reuse it. It must be replaced by a new Helite cartridge with the same reference.
• Persons (including children) with reduced physical, sensory or mental capabilities
wearing the airbag vest should always be accompanied by a responsible adult when
repacking it to avoid any mistakes.
HOW TO RECONDITION THE AIRBAG VEST?
You will need the airbag vest and a new Helite cartridge of the same reference (e-60
cc or e-100 cc depending on the size of your airbag vest, see page 26).
1
The airbag vest has just inated. A red
LED will ash and you will hear beeps.
The airbag vest will automatically switch
o after 30 seconds. If it does not, swit-
ch it o by pressing the ON/OFF button
3 times (see page 31). As soon as you
are safe, you can remove the airbag vest.
Check the condition of the airbag vest,
especially in case of impact with a sharp
object: tear, hole.
2
Remove the empty cartridge. To access it, open the pocket located on the right
side of the airbag vest. Unplug the cartridge
(CAUTION, unlock the clip),
remove the elastic band and unscrew the cartridge.
To Next Page
Loading...
Need help?
General
