HELIX DSP PRO - Installation; Adjusting Highlevel Input Sensitivity; Adjusting Channel G&H Input Sensitivity

17
Installation
Channel assignment:
Channel A
Channel B
Channel C
Channel D
Channel H
Channel G
Channel F
Channel E
Adjustment of the input sensitivity for using channel G & H
as aux inputs:
Jumper below*
Channel G & H:
2 V 4 V*
Jumper above
Channel G & H:
250 mV 500 mV
Fig. 1
Fig. 3
Adjustment of the input sensitivity of the
highlevel inputs:
Jumper above* Jumper below
2 V 4 V*
5 V 10 V*
RCA / Cinch
2 V 4 V
Highlevel
10 V 20 V
Input impedance
30 Ohm 4 kOhm
* Ex factory adjustment of HELIX DSP PRO
Fig. 2